120 mm swords?

[godfather]

anybody sell 120 mm swords metal or resin? I hate when I buy a resin figure and the sword blade is bent as is the case with two figures of mine. BTW any good way of straightening resin?

 

[frank h]

Hi Talino,
A friend of mine makes a plaster mould
and takes a casting of the sword blade in metal

comes out covered in flash but cleans up nicely

Hope this helps

Frank

 

[garyjd]

I would boil some water and then submerge the piece for a bit, pull it out and tape it flat with masking tape to something rigid like a ceramic tile. Just use some caution as to how much heat you expose the piece too.~Gary