75mm-1/24 Victorian Bobby?

[JasonB]

I was wondering if anyone is aware of a British Bobby figure circa 1888 in the above scale? I am pondering a Jack the Ripper Vignette and would like to find something that could be converted to holding a torch. It would go with the Scale 75 JtR figure.Thanks

 

[Warren SMITH]

I believe Pheonix miniatures did one, back in the day, stood with his hands behind his back.. Maybe someone will have him in there stash..

 

[Landrotten Highlander]

Chronos had one but I believe it was 54 mm - goes well with his Sherlock Holms figure in the same scale. Perhaps you can contact them and ask if they could produce it at 75mm (3D printing?)

 

[nig-g]

Stadden (Buckingham Pewter) used to produce a couple of police figures (both modern and historic) although if I remember rightly there were about 90mm. Might be worth look at as scales can vary. Might also need a bit of simple conversion work (high collar instead of shirt and tie etc). Just had a look and there some available on ebay at not too silly prices.
hope this helps.
Nigel

 

[fogie]

I believe Pheonix miniatures did one, back in the day, stood with his hands behind his back.. Maybe someone will have him in there stash..

They certainly did and I believe S&D still have it......it's 1/32nd though.

Mike