Back to Alpine's 1/16th scale German U-Boat Watch Officer, kit #16036
Keeping my method of madness going as before I applied the pre-shade on the upper torso. It may look a bit heavy in some areas, but the gray tones will feather in just fine when I start the process.
The key here is when the oils are applied I keep them within the same tonal range as the Captain figure. If the tones are too far off the figures won't mesh when it comes time to secure them to the gun deck. So, I'll complete the upper torso first, then move onto the legs just like our Captain figure.
Blending the Coat
With the color tones laid out as before I began with the darkest shades first placing a small spread in the upper portion of the creases. Then, taking the wider brush I feathered and blended the oils out to the sides and downward. I will continue with this particular tone until the front of the coat has been treated, then do the same on the back of the coat.
After the initial tone is in place I step up a shade lighter and spread just below the prior tone and feather and blend it. As I said, I will continue this same process on the back of the coat as well to insure uniformity with the gray tones. I noticed a slight variation from the front, back, and sleeves on the last figure, so proceeding in this manner will cut down on the variations. Slight variations are not a big deal, it's when you get tone differences that are obvious, then it becomes a problem.
You may not have noticed it, but I did. The tonal difference on the jacket vs. the trousers is more towards the gray, on the trousers, rather than the more bluish tint of the jacket. See the pics below. this really isn't a big deal, they're two separate articles of clothing and should most often have a slight variation. I just don't want to get too far afield with the variations.
More to follow, and thanks for watchin. Cheers, Ski.
