Katjuscha
Well-Known Member
- Joined
- Jun 14, 2012
- Messages
- 97
Hello,
I want to present to you the Elf Archer “Llyv'ia”:
The solid box depicts the 3D sculpt. Inside all parts are well protected with bubble foil. There are no instruction- or painting-sheets so you have to use the sketches and box art from homepage.
All parts together. The casting is well done without any mistakes like air bubbles etc. Just a little bit of flash. All casting blocks are small and easy to remove.
The elf body. The attachment pins are solid and guarantee good fitting. Surface is clean, well detailed and no 3D printing marks are visible on the castings.
Note the fine fingers without any casting mistakes. The arrow should be bent after warming with hot water. A bowstring is not included and might be added by your own.
The base. Solid and suitable for Tabletop-gaming.
The box art from Limbo's homepage.
Conclusion:
A well-made Elf Archer with just a few rework. For fans of Fantasy figures who want to put it into a display case. In my opinion the resin legs without a wire are to fragile for Tabletop-gaming.
Llyv'ia is available for ~48 $ directly from Limbo Miniatures or at Tabletop- and Fantasyfigure-stores.
I hope you will enjoy the figure.
Thank you very much Kevin for the review samples!
Best regards
Philip
I want to present to you the Elf Archer “Llyv'ia”:
- Manufacturer: Limbo Miniatures
- Reference: EW75-LLYV'IA
- Series: Limbo: Eternal War
- Scale: 75 mm
- Sculptor: Joaquin Palacios (3D-Sculpt)
- Box Art: Marko Miladinović
- Material: Grey Resin
- Parts: 6
The solid box depicts the 3D sculpt. Inside all parts are well protected with bubble foil. There are no instruction- or painting-sheets so you have to use the sketches and box art from homepage.
All parts together. The casting is well done without any mistakes like air bubbles etc. Just a little bit of flash. All casting blocks are small and easy to remove.
The elf body. The attachment pins are solid and guarantee good fitting. Surface is clean, well detailed and no 3D printing marks are visible on the castings.
Note the fine fingers without any casting mistakes. The arrow should be bent after warming with hot water. A bowstring is not included and might be added by your own.
The base. Solid and suitable for Tabletop-gaming.
The box art from Limbo's homepage.
Conclusion:
A well-made Elf Archer with just a few rework. For fans of Fantasy figures who want to put it into a display case. In my opinion the resin legs without a wire are to fragile for Tabletop-gaming.
Llyv'ia is available for ~48 $ directly from Limbo Miniatures or at Tabletop- and Fantasyfigure-stores.
I hope you will enjoy the figure.
Thank you very much Kevin for the review samples!
Best regards
Philip
