Steampunk Cyclomaton Mk II

planetFigure

Help Support planetFigure:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

AJLaFleche

A Fixture
Joined
Oct 29, 2004
Messages
978
Location
West Springfield MA
Here is Smart Max’s resin Cyclomaton Mk II in 1/35 scale.
According to their website, “Following the explosion of the protoplasmic capacitor and the lynching of several members of the Mekazylum, most Steamlords have felt the need for a dissuasive personal support. Heavily armed and very mobile, Cyclomatons reliably fulfil that purpose. At least as long as the parameters of their mission are not too numerous. Thus, Cyclomatons love simplicity – in a very mechanical way, of course -, so make sure they never regard you as « superfluous data » !”
Source: Smart Max.
Kit is built oob with a Plus Models dead rat in the street.
DSCF9455.jpg


DSCF9456.jpg


DSCF9453.jpg


DSCF9452.jpg


DSCF9451.jpg


DSCF9450.jpg


DSCF9447.jpg


DSCF9446.jpg


DSCF9445.jpg


DSCF9444.jpg


DSCF9442.jpg

 
Thanks, Gordy.
The kit only consisted of 8 main parts plus the wing nuts on the wheels. Front wheel, fork, head, gun, engine/exhaust, air filter, frame/rear wheel, base. There was an extra wing nut of a sprue, a nice touch for such small parts. Aligning the part with the air filter to the stem which also holds the head was the only challenge, and quite minor at that. I drilled a tiny hole in the front tire and used a piece or wire to stabilize the kit to the base. I drilled out the barrels on the Gatling gun, too. The kit, including the resin base, is about as tall as a La Meridian 54mm figure.
 
Thanks, Gordy.
The kit only consisted of 8 main parts plus the wing nuts on the wheels. Front wheel, fork, head, gun, engine/exhaust, air filter, frame/rear wheel, base. There was an extra wing nut of a sprue, a nice touch for such small parts. Aligning the part with the air filter to the stem which also holds the head was the only challenge, and quite minor at that. I drilled a tiny hole in the front tire and used a piece or wire to stabilize the kit to the base. I drilled out the barrels on the Gatling gun, too. The kit, including the resin base, is about as tall as a La Meridian 54mm figure.

Thanks for the info AJ :)

It does look quite delicate, but tons of fun!
 
Back
Top