Katjuscha
Well-Known Member
- Joined
- Jun 14, 2012
- Messages
- 97
Hello,
I want to present to you the Demon Hunter “Henril”:

The solid box depicts the 3D sculpt. Inside all parts are well protected with bubble foil. There are no instruction- or painting-sheets so you have to use the sketches from homepage. I couldn't find an official box art.

The hunter's body. The casting is well done without any mistakes like air bubbles etc. Just a little bit of flash. All casting blocks are small and easy to remove. The attachment pins are solid and guarantee good fitting. Surface is clean, well detailed and no 3D printing marks are visible on the castings. The chain has to be attached to the shoulder parts. The endings are casted solid into the Resin. In my opinion it would be more senseful to replace them by the whole metal chain.

The smaller parts, the black chain is missing. Note the fine fingers without any casting mistakes. The strap belongs to the trenchcoat. Strap and scabbard have no attachment pins and could easily break. Instead of bolts there are arrows in the quiver - Fantasy makes possible...

The crossbow is solid. The bow from sight has to be drilled out. A bowstring is not included and might be added by your own.

The base. Simple, solid and suitable for Tabletop-gaming.
Conclusion:
A well made Demon Hunter with just a few rework. For fans of Fantasyfigures and Tabletop-gaming.
Henril is available for ~48 $ directly from Limbo Miniatures or at Tabletop- and Fantasyfigure-Stores.
I hope you will enjoy the figure.
Thank you very much Kevin for the review samples!
Best regards
Philip
I want to present to you the Demon Hunter “Henril”:
- Manufacturer: Limbo Miniatures
- Reference: EW75-HENRIL
- Series: Limbo: Eternal War
- Scale: 75 mm
- Sculptor: Charles Agius (3D-Sculpt)
- Material: Grey Resin and metal
- Parts: 8 Resin parts and 1 metal chain

The solid box depicts the 3D sculpt. Inside all parts are well protected with bubble foil. There are no instruction- or painting-sheets so you have to use the sketches from homepage. I couldn't find an official box art.


The hunter's body. The casting is well done without any mistakes like air bubbles etc. Just a little bit of flash. All casting blocks are small and easy to remove. The attachment pins are solid and guarantee good fitting. Surface is clean, well detailed and no 3D printing marks are visible on the castings. The chain has to be attached to the shoulder parts. The endings are casted solid into the Resin. In my opinion it would be more senseful to replace them by the whole metal chain.


The smaller parts, the black chain is missing. Note the fine fingers without any casting mistakes. The strap belongs to the trenchcoat. Strap and scabbard have no attachment pins and could easily break. Instead of bolts there are arrows in the quiver - Fantasy makes possible...


The crossbow is solid. The bow from sight has to be drilled out. A bowstring is not included and might be added by your own.


The base. Simple, solid and suitable for Tabletop-gaming.
Conclusion:
A well made Demon Hunter with just a few rework. For fans of Fantasyfigures and Tabletop-gaming.
Henril is available for ~48 $ directly from Limbo Miniatures or at Tabletop- and Fantasyfigure-Stores.
I hope you will enjoy the figure.
Thank you very much Kevin for the review samples!
Best regards
Philip