- Joined
- Aug 13, 2009
- Messages
- 6,093
New release from Oakwood Studios called "Broken Bread"
75mm resin & white metal
Sculptor & box artist Adam McMaster
Price: £35.00
Roman legionary (approx. 1st to early 2nd century AD) on the campaign trail but in a relaxed pose, leaning against a tree trunk and handing a piece of bread to an unseen comrade during a break in their long march.
The majority of the kit is resin, but the six parts of his personal gear at bottom right in my photo of the unassembled kit are cast in white metal.
Not being an "expert" on the subject, I'll leave any "historical accuracy" debate to others. Suffice to say that the sculpting and casting are both excellent, and having now removed the casting plugs from the main components I can confirm that their fit is likewise excellent. However, the mating surfaces at the shoulders are flat, so some might prefer to pin these for extra stability.
The cape slots beautifully over his shoulders, and with that in place the figure slots perfectly into place against the tree trunk. Going by my dry fits, I don't anticipate having to use any filler at all anywhere on this one.
The casting plugs on the elbows are a tad clunky, and the one on the back of the helmet needs a bit of care during removal. But on my example there are no visible seam lines or air bubbles, and clean-up promises to be minimal.
Richard cast 10 of these initially to test the water, and I picked up one of them in July. I understand that this initial batch has now all been sold and that a second casting run is in the offing (if not already completed).
Anyone wanting one of these, drop Richard an e-mail to
Richard@Oakwood-Studios.co.uk
Or you can contact him via the Oakwood Studios page on Facebook.
- Steve
75mm resin & white metal
Sculptor & box artist Adam McMaster
Price: £35.00
Roman legionary (approx. 1st to early 2nd century AD) on the campaign trail but in a relaxed pose, leaning against a tree trunk and handing a piece of bread to an unseen comrade during a break in their long march.
The majority of the kit is resin, but the six parts of his personal gear at bottom right in my photo of the unassembled kit are cast in white metal.
Not being an "expert" on the subject, I'll leave any "historical accuracy" debate to others. Suffice to say that the sculpting and casting are both excellent, and having now removed the casting plugs from the main components I can confirm that their fit is likewise excellent. However, the mating surfaces at the shoulders are flat, so some might prefer to pin these for extra stability.
The cape slots beautifully over his shoulders, and with that in place the figure slots perfectly into place against the tree trunk. Going by my dry fits, I don't anticipate having to use any filler at all anywhere on this one.
The casting plugs on the elbows are a tad clunky, and the one on the back of the helmet needs a bit of care during removal. But on my example there are no visible seam lines or air bubbles, and clean-up promises to be minimal.
Richard cast 10 of these initially to test the water, and I picked up one of them in July. I understand that this initial batch has now all been sold and that a second casting run is in the offing (if not already completed).
Anyone wanting one of these, drop Richard an e-mail to
Richard@Oakwood-Studios.co.uk
Or you can contact him via the Oakwood Studios page on Facebook.
- Steve
