Sure can Jason, glad you like it.
The ships bulwark comes in a cream coloured resin and the steps are white metal. There are 4 pieces - the step, the balustrade part, the backboard that the step rests against, and the floor. These are all textured in wood grain already. I first undercoat all the pieces in a matt white spray. Because I wanted the ship to look authentic I used different methods of painting with most of the pieces. The backboard and balustrade were first painted in Citadel Elf flesh acrylic. This is allowed to dry thoroughly before I liberally paint Burnt Sienna oil paint over the parts. Then after a few minutes to let the paint soak in a little I use a clean tissue and a thick brush to remove all excess oil paint, leaving the oil settled into all the crevasses. I use the brush to stroke along the grain of the wood leaving extra oil at the top and bottom of the parts which appear as shadow and ingrained dirt. The taking off of the excess oil leaves the lighter acrylic showing underneath and a little practice gives good wood effect. A good way of removing the last bit of unwanted oil is to use the side of the brush taking care not to get the bristles into the grain.
The step was painted in Games Workshop Dark Flesh acrylic and when thoroughly dry I used the beforementioned Elf Flesh acrylic to drybrush over the edges and the woodgrain of the steps giving a slightly different colouring compared to the earlier mentioned parts.
Finally the floor was first painted in Games Workshop Codex Grey acrylic then when dry I used very thinned down Burnt Umber oil paint to wash over the floor settling into the woodgrain. I dried this using a hairdryer and then when thoroughly dry gave it another wash of thinned down oils, this time I used Lamp Black. Again I dried the part thoroughly before drybrushing it in first Elf Flesh then a light drybrush in Citidel Skull White acrylic.
By using these different methods it makes the scene look more interesting IMO and I think more realistic as it is not all the same shade. The main thing that I need to stress is to make sure the parts are absolutely dry before moving onto the next level or it will start to look a bit muddy.
Good luck with your painting.